Electroplating Makes 3D-Printed Star Wars Prop Shine

Electroplating Makes 3D-Printed Star Wars Prop Shine

3D printing is identified for producing elements with a fairly common finish at most effective. Even the smoothest resin prints are continue to rather plasticky and dull in appearance. On the other hand, it’s achievable to do much far better if you get imaginative with electroplating. This thermal detonator prop from [HEN3DRIK] displays just how very good a 3D print can appear with a very little article-processing and some chemical assist.

[HEN3DRIK] started with a Star Wars thermal detonator design observed on line, and printed it in resin for the ideal achievable floor finish from the get go. The pieces were cleaned just after printing and cured, as for every normal resin processing tactics. From there, great steel wool and sandpaper was utilised to make the print as easy as possible. A conductive layer of copper paint was then sprayed on with an airbrush, with mating surfaces masked off to stay away from ruining the fit.

The section was then dunked in an acidic copper bath even though attached to a electricity source, and carefully rotated for the duration of the electroplating approach. The final results have been outstanding, resulting in close to-mirror finish copper-plated components immediately after sprucing. Nickel was then plated on major to get the prop to the proper silver shade. The prop was eventually then assembled with an Arduino Nano within to operate numerous LEDs for visible influence.

Electroplating isn’t just for producing things quite. It can also add strength to your 3D prints, way too! Movie following the break.

[Thanks to Keith Olson for the tip!]

Leave a Reply